Koate-DVI is indicated for the treatment of classical hemophilia (hemophilia A) in which there is a demonstrated deficiency of activity of the plasma clotting factor, factor VIII. Koate-DVI provides a means of temporarily replacing the missing clotting factor in order to control or prevent bleeding episodes, or in order to perform emergency and elective surgery on individuals with hemophilia.

Koate-DVI contains naturally occurring von Willebrand's factor, which is co-purified as part of the manufacturing process.

Koate-DVI has not been investigated for efficacy in the treatment of von Willebrand's disease, and hence is not approved for such usage.

Each bottle of Koate-DVI has the Antihemophilic Factor (Human) content in International Units per bottle stated on the label of the bottle. The reconstituted product must be administered intravenously by either direct syringe injection or drip infusion. The product must be administered within 3 hours after reconstitution.

General Approach to Treatment and Assessment of Treatment Efficacy

The dosages described below are presented as general guidance. It should be emphasized that the dosage of Koate-DVI required for hemostasis must be individualized according to the needs of the patient, the severity of the deficiency, the severity of the hemorrhage, the presence of inhibitors, and the factor VIII level desired. It is often critical to follow the course of therapy with factor VIII level assays.

The clinical effect of Koate-DVI is the most important element in evaluating the effectiveness of treatment. It may be necessary to administer more Koate-DVI than would be estimated in order to attain satisfactory clinical results. If the calculated dose fails to attain the expected factor VIII levels, or if bleeding is not controlled after administration of the calculated dosage, the presence of a circulating inhibitor in the patient should be suspected. Its presence should be substantiated and the inhibitor level quantitated by appropriate laboratory tests.

When an inhibitor is present, the dosage requirement for AHF(H) is extremely variable and the dosage can be determined only by the clinical response. Some patients with low titer inhibitors, (10 Bethesda Units) can be successfully treated with factor VIII without a resultant anamnestic rise in inhibitor titer.¹² Factor VIII levels and clinical response to treatment must be assessed to insure adequate response. Use of alternative treatment products, such as Factor IX Complex concentrates, Antihemophilic Factor (Porcine) or Anti-Inhibitor Coagulant Complex, may be necessary for patients with high titer inhibitors. Immune tolerance therapy using repeated doses of FVIII concentrate administered frequently on a predetermined schedule may result in eradication of the FVIII inhibitor.^13,14 Most successful regimens have employed high doses of FVIII administered at least once daily, but no single dosage regimen has been universally accepted as the most effective. Consultation with a hemophilia expert experienced with the management of immune tolerance regimens is also advisable.

Calculation of Dosage

The in vivo percent elevation in factor VIII level can be estimated by multiplying the dose of AHF(H) per kilogram of body weight (IU/kg) by 2%. This method of calculation is based on clinical findings by Abildgaard et al,¹⁵ and is illustrated in the following examples:

or

The dosage necessary to achieve hemostasis depends upon the type and severity of the bleeding episode, according to the following general guidelines:

Mild Hemorrhage

Mild superficial or early hemorrhages may respond to a single dose of 10 IU per kg,¹⁶ leading to an in vivo rise of approximately 20% in the factor VIII level. Therapy need not be repeated unless there is evidence of further bleeding.

Moderate Hemorrhage and Minor Surgery

For more serious bleeding episodes (e.g., definite hemarthroses, known trauma), the factor VIII level should be raised to 30%-50% by administering approximately 15 - 25 IU per kg. If further therapy is required, repeated doses of 10 - 15 IU per kg every 8-12 hours may be given.¹⁷

Severe Hemorrhage

In patients with life-threatening bleeding or possible hemorrhage involving vital structures (e.g., central nervous system, retropharyngeal and retroperitoneal spaces, iliopsoas sheath), the factor VIII level should be raised to 80% - 100% of normal in order to achieve hemostasis. This may be achieved in most patients with an initial AHF [Antihemophilic Factor (Human), Koate®-DVI] dose of 40-50 IU per kg and a maintenance dose of 20-25 IU per kg every 8-12 hours.^18,19 For major surgical procedures, Factor VIII levels should be checked throughout the perioperative course to ensure adequate replacement therapy.

Surgery

For major surgical procedures, the factor VIII level should be raised to approximately 100% by giving a preoperative dose of 50 IU/kg. The factor VIII level should be checked to assure that the expected level is achieved before the patient goes to surgery. In order to maintain hemostatic levels, repeat infusions may be necessary every 6 to 12 hours initially, and for a total of 10 to 14 days until healing is complete. The intensity of factor VIII replacement therapy required depends on the type of surgery and postoperative regimen employed. For minor surgical procedures, less intensive treatment schedules may provide adequate hemostasis.^18,19

Prophylaxis

Factor VIII concentrates may also be administered on a regular schedule for prophylaxis of bleeding, as reported by Nilsson et al.²⁰

Incorrect diagnosis, inappropriate dosage, method of administration, and biological differences in individual patients, could reduce the efficacy of this product or even result in an ill effect following its use. It is important that this product be stored properly, the directions for use be followed carefully during use, the risk of transmitting viruses be carefully weighed before the product is prescribed, and that plasma factor VIII levels be measured in initial treatment situations or if clinical response appears inadequate.

Reconstitution

Vacuum Transfer

Note: Aseptic technique should be carefully followed. All needles and vial tops that will come into contact with the product to be administered via the intravenous route should not come in contact with any non-sterile surface. Any contaminated needles should be discarded by placing in a puncture proof container, and new equipment should be used.

1. After removing all items from the box, warm the sterile water (diluent) to room temperature (25^°C, 77^°F).
2. Remove shrink band from product vial.
3. Remove the plastic flip tops from each vial (Fig. A). Cleanse vial tops (grey stoppers) with alcohol swab and allow surface to dry. After cleaning, do not allow anything to touch the latex (rubber) stopper.
4. Carefully remove the plastic sheath from the short end of the transfer needle. Insert the exposed needle into the diluent vial to the hub. (Fig. B)
5. Carefully grip the sheath of the other end of the transfer needle and twist to remove it.
6. Invert the diluent vial and insert the attached needle into the vial of concentrate at a 45^° angle (Fig. C). This will direct the stream of diluent against the wall of the concentrate vial and minimize foaming. The vacuum will draw the diluent into the concentrate vial. **
7. Remove the diluent bottle and transfer needle (Fig. D).
8. Immediately after adding the diluent, agitate vigorously for 10-15 seconds, (Fig. E1) then swirl continuously until completely dissolved (Fig. E2). Some foaming will occur, but attempt to avoid excessive foaming. The vial should then be visually inspected for particulate matter and discoloration prior to administration.
9. Clean the top of the vial of reconstituted Koate-DVI again with alcohol swab and let surface dry.
10. Attach the filter needle (from the package) to a sterile syringe. Withdraw the Koate-DVI solution into the syringe through the filter needle (Fig. F).
11. Remove the filter needle from the syringe and replace with an appropriate injection or butterfly needle for administration. Discard filter needle into a puncture proof container.
12. If the same patient is using more than one vial of Koate-DVI, the contents of multiple vials may be drawn into the same syringe through the filter needles provided.

**If vacuum is lost in the concentrate vial, use a sterile syringe and needle to remove the sterile water from the diluent vial and inject it into the concentrate vial, directing the stream of fluid against the wall of the vial.

A number of factors beyond our control could reduce the efficacy of this product or even result in an ill effect following its use. These include improper storage and handling of the product after it leaves our hands, diagnosis, dosage, method of administration, and biological differences in individual patients. Because of these factors, it is important that this product be stored properly, that the directions be followed carefully during use, and that the risk of transmitting viruses be carefully weighed before the product is prescribed.

Rate of Administration

The rate of administration should be adapted to the response of the individual patient, but administration of the entire dose in 5 to 10 minutes is generally well-tolerated.

Parenteral drug products should be inspected visually for particulate matter and discoloration prior to administration, whenever solution and container permit.

Koate-DVI is supplied in the following single dose bottles with the total units of factor VIII activity stated on the label of each bottle. A suitable volume of Sterile Water for Injection, USP, a sterile double-ended transfer needle, a sterile filter needle, and a sterile administration set are provided.

STORAGE

Koate-DVI should be stored under refrigeration (2-8^°C; 36-46^°F). Storage of lyophilized powder at room temperature (up to 25^°C or 77^°F) for 6 months, such as in home treatment situations, may be done without loss of factor VIII activity. Freezing should be avoided as breakage of the diluent bottle might occur.

CAUTION

Rx Only

U.S. federal law prohibits dispensing without prescription.

REFERENCES

1. Hershgold EJ, Pool JG, Pappenhagen AR: The potent antihemophilic globulin concentrate derived from a cold insoluble fraction of human plasma: characterization and further data on preparation and clinical trial. J Lab Clin Med 67(1):23-32, 1966.
2. Data on file at Bayer Corporation.
3. Aronson DL: Factor VIII (antihemophilic globulin). Semin Thromb Hemostas 6(1):12-27, 1979.
4. Britton M, Harrison J, Abildgaard CF: Early treatment of hemophilic hemarthroses with minimal dose of new factor VIII concentrate. J Pediatr 85(2):245-7, 1974.
5. Winkelman L., Feldman PA, Evan DR: Severe heat treatment of lyophilised coagulation factors in Virus Inactivation in Plasma Products. Curr Stud Hematol Blood Transfus. Morgenthaler J-J (ed.), Basel, Karger, 1989, No. 56, pp. 55-69.
6. Skidmore SJ, Pasi KJ, Mawson SJ, et al: Serological evidence that dry heating of clotting factor concentrates prevents transmission of non-A, non-B hepatitis. J. Med Virol. 30(1):50-2, 1990.
7. Hart HF, Hart WG, Crossley J, et al: Effect of terminal (dry) heat treatment on non-enveloped viruses in coagulation factor concentrates. Vox Sang 67(4): 345-50, 1994.
8. National Hemophilia Foundation Medical and Scientific Advisory Council. Hemophilia Information Exchange-AIDS Update: Recommendations concerning AIDS and the treatment of hemophilia HIV infection. Section I.G. (Rev. Jan., 1988).
9. Safety of therapeutic products used for hemophilia patients. MMWR 37(29):441-4, 449-50, 1988.
10. Eyster ME, Bowman HS, Haverstick JN: Adverse reactions to factor VIII infusions. [letter] Ann Intern Med 87(2):248, 1977.
11. Prager D, Djerassi I, Eyster ME, et al: Pennsylvania state-wide hemophilia program: summary of immediate reactions with the use of factor VIII and factor IX concentrate. Blood 53(5):1012-3, 1979.
12. Kasper CK: Complications of hemophilia A treatment: factor VIII inhibitors. Ann NY Acad Sci 614:97-105, 1991.
13. Mariani G, Hilgartner M, Thompson AR, et al: Immune Tolerance to Factor VIII: International Registry Data. Adv Exp Med Biol 386:201-8, 1995.
14. DiMichele D: Hemophilia 1996, New Approach to an Old Disease. Pediatr Clin North Am 43(3):709-35, Jun 1995.
15. Abildgaard CF, Simone JV, Corrigan JJ, et al: Treatment of hemophilia with glycine-precipitated factor VIII. N Engl J Med 275(9):471-5, 1966.
16. Britton M, Harrison J, Abildgaard CF: Early treatment of hemophilic hemarthroses with minimal dose of new factor VIII concentrate. J Pediatr 85(2):245-7, 1974.
17. Abildgaard CF: Current concepts in the management of hemophilia. Semin Hematol 12(3):223-32, 1975.
18. Hilgartner MW: Factor replacement therapy. In: Hilgartner MW, Pochedly C, eds.: Hemophilia in the child and adult. New York, Raven Press, 1989, pp 126.
19. Kasper CK, Dietrich SL: Comprehensive management of haemophilia. Clin Haematol 14(2):489-512, 1985.
20. Nilsson IM, Berntorp E, Löfqvist T, et al: Twenty-five years' experience of prophylactic treatment in severe haemophilia A and B. J Intern Med 232(1):2532, 1992.

Bayer
Bayer Corporation
Pharmaceutical Division
Elkhart, IN 46515 USA
U.S. License No. 8       08848621
Printed in the USA.       (Rev. April 2003)

Bookmark this page: