Recommended Topic Related To:

Ketalar

"The U.S. Food and Drug Administration today approved Vimizim (elosulfase alfa), the first FDA-approved treatment for Mucopolysaccharidosis Type IVA (Morquio A syndrome). Morquio A syndrome is a rare, autosomal recessive lysosomal storage disease "...

Ketalar

Indications
Dosage
How Supplied

INDICATIONS

Ketalar is indicated as the sole anesthetic agent for diagnostic and surgical procedures that do not require skeletal muscle relaxation. Ketalar is best suited for short procedures but it can be used, with additional doses, for longer procedures.

Ketalar is indicated for the induction of anesthesia prior to the administration of other general anesthetic agents.

Ketalar is indicated to supplement low-potency agents, such as nitrous oxide.

Specific areas of application are described in the CLINICAL PHARMACOLOGY Section.

DOSAGE AND ADMINISTRATION

Note: Barbiturates and Ketalar, being chemically incompatible because of precipitate formation, should not be injected from the same syringe.

If the Ketalar dose is augmented with diazepam, the two drugs must be given separately. Do not mix Ketalar and diazepam in syringe or infusion flask. For additional information on the use of diazepam, refer to the WARNINGS and DOSAGE AND ADMINISTRATION Sections of the diazepam insert.

Preoperative Preparations

  1. While vomiting has been reported following Ketalar administration, some airway protection may be afforded because of active laryngeal-pharyngeal reflexes. However, since aspiration may occur with Ketalar and since protective reflexes may also be diminished by supplementary anesthetics and muscle relaxants, the possibility of aspiration must be considered. Ketalar is recommended for use in the patient whose stomach is not empty when, in the judgment of the practitioner, the benefits of the drug outweigh the possible risks.
  2. Atropine, scopolamine, or another drying agent should be given at an appropriate interval prior to induction.

Onset and Duration

Because of rapid induction following the initial intravenous injection, the patient should be in a supported position during administration.

The onset of action of Ketalar is rapid; an intravenous dose of 2 mg/kg (1 mg/lb) of body weight usually produces surgical anesthesia within 30 seconds after injection, with the anesthetic effect usually lasting five to ten minutes. If a longer effect is desired, additional increments can be administered intravenously or intramuscularly to maintain anesthesia without producing significant cumulative effects.

Intramuscular doses, in a range of 9 to 13 mg/kg (4 to 6 mg/lb) usually produce surgical anesthesia within 3 to 4 minutes following injection, with the anesthetic effect usually lasting 12 to 25 minutes.

Dosage

As with other general anesthetic agents, the individual response to Ketalar is somewhat varied depending on the dose, route of administration, and age of patient, so that dosage recommendation cannot be absolutely fixed. The drug should be titrated against the patient's requirements.

Induction

Intravenous Route: The initial dose of Ketalar administered intravenously may range from 1 mg/kg to 4.5 mg/kg (0.5 to 2 mg/lb). The average amount required to produce five to ten minutes of surgical anesthesia has been 2 mg/kg (1 mg/lb).

Alternatively, in adult patients an induction dose of 1 mg to 2 mg/kg intravenous ketamine at a rate of 0.5 mg/kg/min may be used for induction of anesthesia. In addition, diazepam in 2 mg to 5 mg doses, administered in a separate syringe over 60 seconds, may be used. In most cases, 15 mg of intravenous diazepam or less will suffice. The incidence of psychological manifestations during emergence, particularly dream-like observations and emergence delirium, may be reduced by this induction dosage program.

Note: The 100 mg/mL concentration of Ketalar should not be injected intravenously without proper dilution. It is recommended the drug be diluted with an equal volume of either Sterile Water for injection, USP, Normal Saline, or 5% Dextrose in Water.

Rate of Administration

It is recommended that Ketalar be administered slowly (over a period of 60 seconds). More rapid administration may result in respiratory depression and enhanced pressor response.

Intramuscular Route

The initial dose of Ketalar administered intramuscularly may range from 6.5 to 13 mg/kg (3 to 6 mg/lb). A dose of 10 mg/kg (5 mg/lb) will usually produce 12 to 25 minutes of surgical anesthesia.

Maintenance of Anesthesia

The maintenance dose should be adjusted according to the patient's anesthetic needs and whether an additional anesthetic agent is employed.

Increments of one-half to the full induction dose may be repeated as needed for maintenance of anesthesia. However, it should be noted that purposeless and tonic-clonic movements of extremities may occur during the course of anesthesia. These movements do not imply a light plane and are not indicative of the need for additional doses of the anesthetic.

It should be recognized that the larger the total dose of Ketalar administered, the longer will be the time to complete recovery.

Adult patients induced with Ketalar augmented with intravenous diazepam may be maintained on Ketalar given by slow microdrip infusion technique at a dose of 0.1 to 0.5 mg/minute, augmented with diazepam 2 to 5 mg administered intravenously as needed. In many cases 20 mg or less of intravenous diazepam total for combined induction and maintenance will suffice. However, slightly more diazepam may be required depending on the nature and duration of the operation, physical status of the patient, and other factors. The incidence of psychological manifestations during emergence, particularly dream-like observations and emergence delirium, may be reduced by this maintenance dosage program.

Dilution

To prepare a dilute solution containing 1 mg of ketamine per mL, aseptically transfer 10 mL (50 mg per mL) or 5 mL (100 mg per mL) to 500 mL of 5% Dextrose Injection, USP or Sodium Chloride (0.9%) Injection, USP (Normal Saline) and mix well. The resultant solution will contain 1 mg of ketamine per mL.

The fluid requirements of the patient and duration of anesthesia must be considered when selecting the appropriate dilution of Ketalar. If fluid restriction is required, Ketalar can be added to a 250 mL infusion as described above to provide a Ketalar concentration of 2 mg/mL.

Ketalar 10 mg/mL are not recommended for dilution.

Supplementary Agents

Ketalar is clinically compatible with the commonly used general and local anesthetic agents when an adequate respiratory exchange is maintained.

The regimen of a reduced dose of Ketalar supplemented with diazepam can be used to produce balanced anesthesia by combination with other agents such as nitrous oxide and oxygen.

HOW SUPPLIED

Ketalar is supplied as the hydrochloride in concentrations equivalent to ketamine base.

NDC 42023-113-10 — Each 20-mL vial contains 10 mg/mL. Supplied in cartons of 10.
NDC
42023-114-10 — Each 10-mL vial contains 50 mg/mL. Supplied in cartons of 10.
NDC 42023-115-10 — Each 5-mL vial contains 100 mg/mL. Supplied in cartons of 10.

Store at 20°–25°C (68°–77°F). (See USP controlled room temperature.)

Protect from light.

Prescribing Information as of February 2009. Manufactured and Distributed by: JHP Pharmaceuticals, LLC, Rochester, MI 48307

Last reviewed on RxList: 3/16/2012
This monograph has been modified to include the generic and brand name in many instances.

Indications
Dosage
How Supplied
A A A

Report Problems to the Food and Drug Administration

 

You are encouraged to report negative side effects of prescription drugs to the FDA. Visit the FDA MedWatch website or call 1-800-FDA-1088.


Women's Health

Find out what women really need.