Recommended Topic Related To:

Proair

"The U.S. Food and Drug Administration will complete its phase-out of all inhaler medical products containing chlorofluorocarbons (CFCs) by Dec. 31, 2013. This effort is to comply with an international treaty to protect the ozone layer by phasing "...

Proair HFA

PATIENT INFORMATION

PROAIR® HFA
(albuterol sulfate) Inhalation Aerosol

Read this leaflet carefully before you start to use PROAIR HFA (albuterol sulfate inhalation aerosol) .

Keep this leaflet because it has important summary information about PROAIR HFA. Your healthcare provider has more information or advice.

Read the new leaflet that comes with each refill of your prescription because there may be new information.

What is PROAIR HFA (albuterol sulfate inhalation aerosol) ?

PROAIR HFA (albuterol sulfate inhalation aerosol) is a kind of medicine called a fast-acting bronchodilator. Fast-acting bronchodilators help to quickly open the airways in your lungs so that you can breathe more easily.

Each dose of PROAIR HFA (albuterol sulfate inhalation aerosol) should last up to 4 to 6 hours.

Take PROAIR HFA (albuterol sulfate inhalation aerosol) as directed by your doctor. Do not take extra doses or take more often without asking your doctor.

Get medical help right away if PROAIR HFA (albuterol sulfate inhalation aerosol) no longer helps your symptoms. Also get medical help if your symptoms get worse or if you need to use your inhaler more often.

While you are using PROAIR HFA (albuterol sulfate inhalation aerosol) , use other inhaled medicines and asthma medicines only as directed by your doctor. Tell your doctor if you are pregnant or nursing, and ask about the use of PROAIR HFA (albuterol sulfate inhalation aerosol) .

Possible side effects of taking PROAIR HFA (albuterol sulfate inhalation aerosol) include fast or irregular heartbeat, chest pain, shakiness, and nervousness. With the first use of a new canister, worsening of wheezing may occur.

The parts of your PROAIR HFA (albuterol sulfate inhalation aerosol) inhaler:

Figure 1

The parts of your PROAIR HFA inhaler - Illustration

There are 2 main parts to your PROAIR HFA (albuterol sulfate inhalation aerosol) inhaler—the metal canister that holds the medicine and the red plastic actuator that sprays the medicine from the canister (see Figure 1).

The inhaler also has a cap that covers the mouthpiece of the actuator.

Do not use the PROAIR HFA (albuterol sulfate inhalation aerosol) actuator with a canister of medicine from any other inhaler. And do not use a PROAIR HFA (albuterol sulfate inhalation aerosol) canister with an actuator from any other inhaler.

How to Use Your PROAIR HFA (albuterol sulfate inhalation aerosol)

Before using your PROAIR HFA (albuterol sulfate inhalation aerosol) :

If a child needs help using the inhaler, an adult should help the child use the inhaler. An adult should watch a child use the inhaler to be sure it is used correctly.

The inhaler should be at room temperature before you use it.

Check each time to make sure the canister fits firmly in the plastic actuator. Also look into the mouthpiece to make sure there are no foreign objects there, especially if the cap is not being used to cover the mouthpiece.

Priming your PROAIR HFA (albuterol sulfate inhalation aerosol) :

You must prime the inhaler to get the right amount of medicine. Prime the inhaler before you use it for the first time or if you have not used it for more than 14 days. To prime the inhaler, take the cap off the mouthpiece of the actuator. Then shake the inhaler well, and spray it into the air away from your face. Shake and spray the inhaler like this 2 more times to finish priming it.

Instructions for taking a dose from your PROAIR HFA (albuterol sulfate inhalation aerosol) :

Read through the 6 steps below before using PROAIR HFA (albuterol sulfate inhalation aerosol) . If you have any questions, ask your doctor or pharmacist.

1. Take the cap off the mouthpiece of the actuator. Shake the inhaler well before each spray.

2. Hold the inhaler with the mouthpiece down (see Figure 2). Breathe out through your mouth and push as much air from your lungs as you can. Put the mouthpiece in your mouth and close your lips around it.

3. Push the top of the canister all the way down while you breathe in deeply and slowly through your mouth (see Figure 3). Right after the spray comes out, take your finger off the canister. After you have breathed in all the way, take the inhaler out of your mouth and close your mouth.

Instructions for taking a dose - Illustration

4. Hold your breath as long as you can, up to 10 seconds, then breathe normally.

5. If your doctor has prescribed more sprays, wait 1 minute and shake the inhaler again. Repeat steps 2 through 4.

6. Put the cap back on the mouthpiece after every time you use the inhaler, and make sure it snaps firmly into place.

When to Replace Your PROAIR HFA (albuterol sulfate inhalation aerosol)

  • Before you reach 200 sprays, you should refill your prescription or ask your doctor if you need another prescription for PROAIR HFA (albuterol sulfate inhalation aerosol) .
  • Throw the inhaler away when you have used 200 sprays. You should not keep using the inhaler after 200 sprays even though the canister may not be completely empty because you cannot be sure you will receive any medicine.
  • Do not use the inhaler after the expiration date, which is on the packaging it comes in.

How to Clean Your PROAIR HFA (albuterol sulfate inhalation aerosol)

It is very important to keep the plastic actuator clean so the medicine will not build-up and block the spray. Do not try to clean the metal canister or let it get wet. The inhaler may stop spraying if it is not cleaned correctly.

Wash the actuator at least once a week.

Cleaning instructions:

  • Take the canister out of the actuator, and take the cap off the mouthpiece.
  • Wash the actuator through the top with warm running water for 30 seconds (see Figure 4). Then wash the actuator again through the mouthpiece (see Figure 5).
Cleaning instructions -  Illustration

  • Shake off as much water from the actuator as you can. Look into the mouthpiece to make sure any medicine build-up has been completely washed away. If there is any build-up, repeat steps in Figures 4 and 5.
  • Let the actuator air-dry completely, such as overnight (see Figure 6).

Figure 6

Let the actuator air-dry - Illustration

  • When the actuator is dry, put the canister in the actuator and make sure it fits firmly. Shake the inhaler well and spray it twice into the air away from your face. Put the cap back on the mouthpiece.

If your actuator becomes blocked:

Blockage from medicine build-up is more likely to happen if you do not let the actuator air-dry completely. If the actuator gets blocked so that little or no medicine comes out of the mouthpiece (see Figures 7 and 8), wash the actuator as described in the “Cleaning Instructions” section above.

Detecting blockages - Illustration

However, if you need to use your inhaler before the actuator is completely dry, shake as much water off the actuator as you can. Put the canister in the actuator and make sure it fits firmly. Shake the inhaler well and spray it twice into the air away from your face. Then take your dose as prescribed. Then clean and air-dry it completely.

Storing Your PROAIR HFA (albuterol sulfate inhalation aerosol)

Store between 15° and 25° C (59° and 77° F). Avoid exposure to extreme heat and cold. For best results, canister should be at room temperature.

Shake well before use.

Contents Under Pressure. Do not puncture. Do not store near heat or open flame. Exposure to temperatures above 120°F may cause bursting. Never throw container into fire or incinerator.

Avoid spraying in eyes. Keep out of reach of children.

For questions related to proper use and maintenance of your PROAIR HFA (albuterol sulfate inhalation aerosol) inhaler, please call Teva Respiratory customer service at 1-888-482-9522.

Last reviewed on RxList: 9/14/2010
This monograph has been modified to include the generic and brand name in many instances.

A A A

Proair HFA - User Reviews

Proair HFA User Reviews

Now you can gain knowledge and insight about a drug treatment with Patient Discussions.

Here is a collection of user reviews for the medication Proair HFA sorted by most helpful. Patient Discussions FAQs

Report Problems to the Food and Drug Administration

 

You are encouraged to report negative side effects of prescription drugs to the FDA. Visit the FDA MedWatch website or call 1-800-FDA-1088.


Allergies & Asthma

Improve treatments & prevent attacks.